Wooden fence slats that haven’t been treated with a wood sealer are prone to damage after excessive exposure to moisture. If a couple of small holes are in one or more of the wooden pieces, they can be patched by completing the following steps for Fence Repair Nassau County. Afterward, both sides of a fence should be cleaned and dried before applying a wood sealing agent to the surface of each slat.
Materials
• wood putty
• caulk gun
• scraper or putty knife
• hand sander
• sandpaper
• all purpose cleaner
• nonabrasive sponge
• drop cloths or sheeting
• tape
• paint roller
• wood sealer
Use Putty To Fill Holes
Wood putty is a repair product that is soft and pliable and that will provide a waterproof surface after it is applied. After filling a caulking cartridge with wood putty, the cartridge should be inserted through the tool’s chamber.
Putty can be released into each hole by pressing the caulk gun’s trigger. A flexible scraper or putty knife should be used to remove excess putty that has been applied to either side of the fence. After putty has hardened, a hand sander can be used to briefly sand the panels after completing the Fence Repair in Nassau County.
For assistance with repairing a fence or advice about products to use to complete a repair project, contact Precision Fence LLC or another company. Information about fencing supplies can be found when a homeowner chooses to visit website.
Clean Fencing And Apply A Sealer
An all purpose cleaning agent should be sprayed across wood panels. A nonabrasive sponge can be used to scrub stained surfaces. Water should be applied liberally to both sides of a fence to rinse away loose dirt and traces of the cleaning agent. Wooden surfaces will require several hours to dry thoroughly.
Before applying a wood sealer to both sides of a fence, drop cloths or plastic sheeting should be laid across the ground. Strips of tape should be secured to hardware or trim that is not going to be coated with a sealer. A paint roller should be used to apply a couple of coats of sealer to each side of a fence.
Each coat should be thin and even, and the first coat will need plenty of time to dry before adding a subsequent coat. After the second coat of sealer has dried, strips of tape can be removed and disposed of.
