A furnace is a mechanism used for heating homes and buildings. It’s a major appliance in many homes across the country. It creates heat by burning gas or propane. The heat exchanger accepts the hot combustion gases. Air is blow over the exterior of the heat exchanger. Cooled gases are vented outside. To keep this process going, it’s important to perform simple heating repair in San Fernando, CA for your gas furnace. Use the following tips for troubleshooting.
If you have a gas furnace that won’t run at all, check the power source. Look for a tripped circuit breaker or blown fuse at the main entrance panel or a separate entrance panel. These safety devices activate when their is an overload of electrical current. Reset a tripped circuit breaker and replace a blown fuse. When this does not work, look for a switch that has been turned off. Look for another switch near the furnace. If you turn it on and the furnace still does not work, there may be a motor overload. Reset the switch to the motor. Wait about 1 hour and reset the button. Ensure that the pilot light is lit. When these actions don’t work, it may be necessary to call a professional.
Another problem many furnace owners complain of is furnaces not providing enough heat. When this happens to your furnace, raise the temperature on the thermostat by 5 degrees. Wait a few minutes. Repeat this step again. If it still does not work, inspect the filter. Clean a dirty filter by rinsing it outside with a water hose. If it’s a disposable one, replace it with a new one. You may have a clogged blower. Clean this component based on instructions provided in the user’s manual. Additional solutions should be explored if your furnace still does put out enough heat.
Troubleshooting a furnace includes learning about your furnace system. Read the user’s manual thoroughly when you get the unit. You can also call the manufacturer to request literature about your furnace. Doing this will help you learn how to perform basic tasks to properly fix your furnace.
